SECTION 307-01: Automatic Transaxle/Transmission — 6R80
2014 Mustang Workshop Manual
DIAGNOSIS AND TESTING
Procedure revision date: 01/07/2013

Transmission Connector Layouts

Transmission Vehicle Harness — C1575


Item Description
1 Turbine Shaft Speed (TSS) sensor signal
2 NOT USED
3 TCC control
4 Transmission Range (TR) sensor
5 Signal return
6 Transmission Fluid Temperature (TFT) sensor signal
7 Ignition voltage
8 Shift Solenoid E (SSE) control
9 Shift Solenoid A (SSA) control
10 Shift Solenoid D (SSD) control
11 TR sensor ground
12 Battery voltage
13 Shift Solenoid C (SSC) control
14 Shift Solenoid B (SSB) control
15 Output Shaft Speed (OSS) sensor signal
16 Pressure Control Solenoid A (PCA) control



Transmission Leadframe Connector


Item Description
1 Turbine Shaft Speed (TSS) sensor signal
2 NOT USED
3 TCC solenoid control
4 Transmission Range (TR) sensor power
5 Signal return
6 Transmission Fluid Temperature (TFT) sensor signal
7 Ignition voltage
8 Shift Solenoid E (SSE) control
9 Shift Solenoid A (SSA) control
10 Shift Solenoid D (SSD) control
11 TR sensor ground
12 Battery voltage
13 Shift Solenoid C (SSC) control
14 Shift Solenoid B (SSB) control
15 Output Shaft Speed (OSS) sensor signal
16 Pressure Control Solenoid A (PCA) control



Molded Leadframe

NOTE: When measuring continuity through the molded leadframe, the common power feed to the solenoids listed in the following chart is terminal 7 at the molded leadframe connector.



Item Description
3 Torque Converter Clutch (TCC) control
8 Shift Solenoid E (SSE) control
10 Shift Solenoid D (SSD) control
16 Pressure Control Solenoid A (PCA) control
13 Shift Solenoid C (SSC) control
14 Shift Solenoid B (SSB) control
9 Shift Solenoid A (SSA) control